What are the daily precautions for Continuous PU foam machine?

Beginners are concerned that if the settling plate is not adjusted properly, the liquid flowing out of the nozzle may cause front surging or back surging, affecting the foaming process. Within two minutes after starting the machine, the reaction speed gradually increases, sometimes requiring adjustments to the settling plate. Adjustments to the settling plate are more critical in low-density and high-moisture-content (MC) formulas.

TDI (Toluene Diisocyanate) flow rate can be calculated to correspond to the scale value, but it is recommended to actually measure the TDI flow rate during the first foaming. Flow rate is too important; if the flow rate is not accurate, everything else will be a mess. It's best to rely on the simplest and most intuitive method of measuring the flow rate.

When mixing powders, the mixed stone powder should be left overnight and production should start the next day. For ingredients containing melamine and stone powder, it is recommended to first mix melamine with polyether for a period of time before adding the stone powder.

Foam machine formulas with long mixing chamber in the machine head or more teeth on the stirring shaft usually have less amine and lower material temperature. Conversely, foam machine formulas with short mixing chamber in the machine head or fewer teeth on the stirring shaft usually have more amine and higher material temperature.

For the same formula, when switching between dual-spray swivel heads and single-spray swivel heads with similar nozzle cross-sectional areas, the requirements for mesh thickness and layers are similar.

For the calibration of minor material flow, one method is to measure the return flow of the minor material, and the other is to calibrate it by dividing the total amount used by the foaming time. When there is a significant difference between the two calibration methods, rely on the data from the second calibration method.

Formulas for high-quality soft foam are usually within an unstable range, such as a low TDI index, low water-to-MC ratio, low T-9 dosage, and low silicone oil dosage.