Basic Knowledge of Polyurethane Foaming Equipment

PLC (Programmable Logic Controller)

It is an automatic control device with instruction memory, digital or analog I/O interfaces; primarily used for logical, sequential, timing, counting, and arithmetic operations with bit operations; used to control machines or production processes.

Variable Frequency Drive (VFD)

A VFD is a control device that transforms power frequency from one frequency to another using the on-off action of power semiconductor devices.

The main circuits of a VFD can generally be divided into two types:

- Voltage type: Converts DC voltage from a voltage source to AC in the VFD, with capacitor filtering in the DC circuit.

- Current type: Converts DC current from a current source to AC in the VFD, with inductor filtering in the DC circuit.

Photoelectric Switch

It utilizes the obstruction or reflection of an infrared light beam by a detected object, detected by the synchronous circuit, to determine the presence or absence of the object. It can detect any object that reflects light, not limited to metals.

A mirror-reflective photoelectric switch is used on the vacuum perforating machine.

Heat Exchanger System

Controls the temperature of raw materials in the system to meet requirements.

As the temperature of the raw material rises after passing through the heat exchanger, its viscosity increases. To ensure the normal operation of the high-pressure pump, a special feeding pump is required. Specific requirements are calculated based on flow rate and raw material viscosity.

The temperature control of the heat exchanger should be near the mixing head, correlating the raw material temperature with the switch of the cooling water to automatically control the flow of cooling water to cool the raw material.

Perforating Machine

There are roller perforating machines, vacuum perforating machines, and brush perforating machines, with roller machines having the best control effect, followed by vacuum perforating machines, and brush perforating machines being the worst. Currently, brush perforating machines are rarely used.

The purpose of perforating is to prevent product deformation.

The roller perforating machine controls the size of the gaps. If the gaps are too large, the perforating effect is not good; if the gaps are too small, there will be obvious pressure marks on the product.

There are two methods of perforating: 1. Chemical method - using perforating agents, 2. Mechanical method - using perforating machines.

Products must be perforated as soon as they come out of the mold. Some products may expand after being demolded, and at this time, they should be left for a period before perforating.

TPR

It can prevent product shrinkage and collapse of bubbles; its most basic function is effective perforating to facilitate demolding. However, it can also lead to fluctuations in ILD (Indentation Load Deflection); TPR directly affects the rise speed of the foam.

Loop Pressure Regulating Valve

It is crucial for balancing system pressure in the control system and should be placed as close to the nozzle as possible. If it is far from the nozzle, pressure fluctuations may occur, leading to system instability and unstable products.